3DMark '13 score thread

[Butuz]

Congrats! 4.7 is nice!! Did you have to raise the voltage much?

Butuz

[KeyboardDemon]

Congrats! 4.7 is nice!! Did you have to raise the voltage much?

Butuz

Thanks.

Had to play with volts a bit, it was up to 1.350 on the CPU just trying to bring it down now, it's stable with 1.320 so will try 1.280 next, just running prime95 right now, but not had any issues with prime so far and it has been running for close to 1hr.

Also set load line calibration to extreme, CPU Voltage Frequency was increased and CPU Current Capability was set to 140% too.

Temps are maxing out at 87 degrees for CPU Package according to hardware monitor, I think getting the voltages down should take another 10 degree off that.

[Butuz]

4.6 is a brick wall on my CPU - it doesn't matter what I do with the volts etc it's just not stable higher

Butuz

[KeyboardDemon]

Setting your CPU Voltage Frequency to 500 should help with stability, CPU current Capability can help your CPU pull more power than its listed TDP, I have mine at 140%, other than that maybe I just got lucky in the Silicon lottery and got a better binned chip or something.

[KeyboardDemon]

Will there be an update to the table soon?

[dfour]

With a little extra voltage

1178 core and 1497 mem and fan @ 80%

http://www.3dmark.com/3dm/2354211

[bob3406]

http://www.3dmark.com/fs/1657000

tasty new crossfire setup... doesn't half run HOT though!

[Butuz]

Good score! Just goes to show 3dmark does not scale anywhere linearly with xfire! 9k for one, 15k for two, 18k for three!

Butuz

[bob3406]

I think the graphics part of the score does scale quite well... I get 11000 graphics score with a single 290, and 20500 with two R9 290 cards. I think the total score is limited by the CPU physics score...

[Dooms]

Hmmmm my score has gone down...

I went from 9906 with CPU@4.4 and GPU's at 1050/1250 a couple months ago

to 9400-9550 with CPU@4.7 and GPU's at 1100/1500

Maybe the difference of having a clean build vs one that is a couple months old? Only other difference is going from the Demo version of 3D Mark to the full version.

[Bagnaj97]

Maybe the difference of having a clean build vs one that is a couple months old? Only other difference is going from the Demo version of 3D Mark to the full version.

Perhaps driver changes? I'm pretty sure AMDs frame pacing changes have had a negative impact on FPS but positive on frame latency.

[Dooms]

Perhaps driver changes? I'm pretty sure AMDs frame pacing changes have had a negative impact on FPS but positive on frame latency.

Yeah maybe. Updated to 14.1 last night and it went down even more (to sub 9000 )

[KeyboardDemon]

Oh yeah!!

I've just seen the updated table and I currently hold the number one slot for fastest single GPU performance score. lol

Finally, my fifteen minutes of fame, I'm going to enjoy it while it lasts, I wonder how long it will stay that way?

*** edit ***
@Bagnaj97: Thanks for keep these scores updated. I'm still willing to help you out with the updates if you'd like some help.

[KeyboardDemon]

Ok. Bagnaj97 is not going to like me now, the table needs a new update, sorry. lol

But I have managed to beat my last score: http://www.3dmark.com/3dm/2386257

[Percy1983]

Thanks for the update, you can remove my line at 40 and just leave 32.

Extremely happy with my score, it appears my PC is punching well above its weight and is winning.

[KeyboardDemon]

Thanks for the update, you can remove my line at 40 and just leave 32.

Extremely happy with my score, it appears my PC is punching well above its weight and is winning.

Well done, nice score, you're beating around 80% of people with similar rigs to yours.